PEGOKUR Tile adhesive / pego

 Packaging: 25 Kg bags

Colors: Grey and White

1. Concrete masonry.
2. Cement mortar bed.
3. Brick Masonry.

1. 1. 1. 1. NOTCH TROWEL  6 mm x 6 mm COVERAGE 8.5–10.0 m2.
         2. NOTCH TROWEL 6 mm x 9 mm COVERAGE 6.5  –7.5 m2.
         3. NOTCH TROWEL 12 mm x 12 mm COVERAGE 4 –5.0 m2.

Shelf Life

Factory sealed containers of this product are guaranteed to be of first quality for 6 month if stored off the ground in a dry area.

Cautions

1. Contains Portland cement,  silica sand and polymers.
2. May irritate eyes and skin.
3. Avoid contact with eyes or prolonged contact with skin. In case of contact, flush thoroughly with water.
4. Do not take internally. Avoid breathing dust. Wear a respirator in dusty areas.
5. Keep out of reach of children.
6. Protect finished work until fully cured

TECHNICAL DATA Working Properties (At 23ºC)

1. Wet density1.70 gm/cm³.
2. Open time  40 minutes.
3. Pot life 2 Hrs.
4. Time to traffic 48 Hrs.

Note: Specifications subject to change without notification. Results shown are typical but reflect test procedures used. Actual field performance will depend on installation methods and site conditions.

 

INSTALLATION

Preparation

All surfaces should be between 5º C to 38º C and structurally sound, clean and free of all dirt, oil, grease, loose peeling paint, laitance, concrete sealers or curing compounds. Rough or uneven concrete surfaces should be made smooth with Portland Cement under layment to provide a better finish. Dry, dusty concrete slabs or masonry should be dampened and excess water swept off. Installation may be made on a damps urface.

Mixing

Place clean potable water into a clean pail. Add Pegokur powder. Use approximately 5 – 5.5 Liters of water for 25 Kg bag of powder. Mix by hand or with a slow speed mixer to a smooth, trowelable consistency. Allow mortar to slake for 5 –10 minutes. Adjust consistency if necessary. Remix and apply with the proper sized notched trowel.

Application
Apply mortar to the substrate with the flat side of the trowel, pressing firmly to work into surface. Comb on additional mortar with the notched side. Note: Use the proper sized notched trowel to insure full bedding of the tile. Spread as much mortar as can be covered with tile in 15-20 minutes. Back butter large tiles (>8”x8”) to provide full bedding and firm support. Place tiles into wet, sticky mortar and beat in using a beating block and rubber mallet to imbed tile and adjust level. Check mortar for complete coverage by periodically removing a tile and inspecting bedding mortar transfer onto back of tile. If mortar is skinned over (not sticky), remove and replace with fresh mortar.

Cleaning

Clean tools and tile work with water while mortar is fresh.